Vasari Wind Analysis Tool - What is under the bonnet...?

Hi All,

I understand that Vasari as a design tool is more geared towards early stages of design and therefore not to be taken too seriously however I am curious to know which calculation method is used, RANS, DES, LES etc... for the CFD type wind analysis? 

Other forum posts seem to lead to the same DOE-2 calculation engine response however I believe DOE-2 is more related to the energy analysis simulations... please correct me if I am wrong. 

Thanks in advance! 

Views: 343

Tags: Calculation, DOE-2, Vasari, engine

Comment by Tom Vollaro on January 23, 2014 at 10:09am

Hi Ross. This doc gives the high level overview of the calculations behind our Wind Tunnel CFD

Comment by RevitTurkiye KullanıcıGrubu on February 19, 2014 at 8:52am

You can get info about CFD in Vasari below;

You can see comparison between "Flow Design" and "Fluent"

Comment by RevitTurkiye KullanıcıGrubu on February 19, 2014 at 8:54am
Comment by Ross Milner on February 19, 2014 at 9:06pm

Thank you very much gentleman. 


You need to be a member of Autodesk Vasari to add comments!

Join Autodesk Vasari

© 2016   Created by Tom Vollaro.   Powered by

Badges  |  Report an Issue  |  Terms of Service